Remove the two screws securing the cover and two mounting screws as shown in figure 1. Exercise caution not to jar the case while replacing the battery, possibly breaking the Tamper breakaway tab. IMPORTANT: When servicing the device for battery replacement, note that with the mounting screws removed the case is held in place by the tamper release tab. Dispose of used batteries promptly and properly. Do not recharge, disassemble, heat above 100☌, or incinerate. Typical Holdup Switch InstallationīATTERY CAUTION: Risk of fire, explosion, and burns. Supplied, Part Number K4563 to order separatelyįigure 3. 6x1/2 IMPORTANT: THIS DEVICE MUST BE PERMANENTLY MOUNTED WITH THE SCREWS SUPPLIED. ADEMCO 466, Duracell DL123A, Panasonic CR123A, Varta CR123A.ĬOVER SCREW (2) No. Reinstall two cover screws and two mounting screws as shown in Figure 1. Observing correct polarity (negative side of the battery facing the trigger), insert the battery into the battery holder as shown in Figure 1. Remove faulty battery and dispose of properly. NOTE: THE NEGATIVE ( - ) SIDE OF THE BATTERY MUST FACE THE TRIGGER Secure the case with the cover to its mounting location using the two screws (No.
IMPORTANT: To prevent damage to the case, do not over tighten the cover screws. Secure the cover to the case with the two screws (No 6 x 1/2) as shown in Figure 3. 6 x ¾ screw (supplied) at the breakaway tamper release hole as shown in Figure 3.
#Resideo panic button install
Position the case to the desired location and install one No. Install the battery into the battery holder observing correct polarity as shown in Figure 2. Before mounting the 5869 permanently, perform Go/No Go tests to verify adequate transmitter signal strength at desired mounting location (refer to the Security System Control Panel Installation and Setup Guide). Refer to the figure and steps that follow for typical mounting installation. Mount the 5869 under a counter or money drawer for easy access by the cashier. The 5869 is one closed input loop zone (loop 1).įigure 1.During programming of the control panel, the 5869 Holdup Switch/Transmitter should be treated as "RF" (i.e., supervised RF) Type.Refer to the Security System Control Panel Installation and Setup Guide for programming instructions. The 5869 Holdup Switch/Transmitter should be programmed as a 24-hour silent zone type. For certified UL installations, the 5869 must be used with the 5881ENHC tamper-protected wireless receiver, mounted inside its plastic enclosure and outside the alarm panel enclosure.ĬOVER TAMPER SWITCH MOUNTING SCREW (2) No. To enroll the 5869, refer to the respective Security System Control Panel Installation and Setup Guide.
#Resideo panic button serial number
The 5869 has a permanent serial number assigned during manufacture used for enrolling the 5869 with the security system control panel. The 5869 also contains tamper switches that are activated either when the cover is removed, or when the unit is forcibly removed from its installation location. Once the 5869 trigger (Figure 1) is activated, the supplied reset key K4563 must be used to reset the device. When the transmitter is activated, it sends an RF signal to the control panel, which then sends a burglary alarm to the central station. The 5869 is typically mounted under a counter or money draw for inconspicuous operation. The ADEMCO 5869 Holdup Switch/Transmitter is a fingeroperated RF transmitting device used for activating a holdup signal at the security system control, and/or any other security application.
0 kommentar(er)
